Information materials

Clear filters

Information materials

    • Separating sheet system using Sopro EM-X 1189 separating mat eXtra

      Separating layer on critical substrates prior to installation of tile and natural stone coverings

    • Separating system for existing coverings using Sopro FDP 558 tile insulation board

      Reliable laying of tiles on critical, e.g. old or cracked, substrates

    • Separating system using Sopro TEB 664 impact sound insulation and separating layer

      Impact sound insulation and separating system below natural stone and ceramic coverings

    • Waterproofing system using Sopro FDF flexible sealing compound

      Permanent protection of bathrooms/wet spaces against moisture penetration to DIN 18534

    • Waterproofing system for heavy-duty areas using Sopro AEB HD 958 sheet membrane

      Waterproofing below ceramic coverings in areas subject to high chemical and mechanical loads

    • Reaction resin waterproofing system (e.g. for food-processing facilities)

      Chemically resistant waterproofing below ceramic coverings, e.g. for catering kitchens or swimming pools

    • Waterproofing system for dry construction substrates using Sopro AEB 640

      Waterproofing and separating layer on indoor dry construction substrates

    • Structural waterproofing using bituminous thick coatings or mineral sealing slurries

      Structural waterproofing using bituminous thick coatings or flexible mineral sealing slurries

    • Structural waterproofing system using bituminous thick coating

      Structural waterproofing using bituminous thick coating to DIN 18533 Part 3

    • Structural waterproofing using self-adhesive SoproThene® bitumen sheet membrane

      Structural waterproofing using cold-applied, self-adhesive bitumen sheet membrane

European Construction Products Regulation (CPR)

Dear Customer

On 1 July 2013, the previously valid Construction Products Directive (CPD 89/106) was superseded by the Construction Products Regulation (CPR 305/2011).

The most important change was undoubtedly the new obligation to draw up a Declaration of Performance (DoP) for each product with a CE marking. This replaced the previous Declaration of Conformity. Manufacturers are now obliged to issue a Declaration of Performance, which, alongside all other relevant information, states the product's performance characteristics with reference to the relevant harmonized technical specification (harmonized EN standard or ETA).

The key purpose of a Declaration of Performance is to provide customers and applicators with the means of comparing the various products available on the market using a set of general, clearly defined and measurable properties. This then enables them to select the product best suited to their particular requirements.

 

Marine Equipment Directive MED 2014/90/EU

Dear Customer

Since 18 September 2016, the MED 2014/90/EU applies. If a wheel mark labelled Sopro product shall be installed on a ship, it is necessary to comply with the associated regulations and to carry the relevant Declarations of Conformity. The documents „MED Declaration of Conformity“ can be found at this Link. A declaration of conformity extended by batch numbers is available on request.